×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerMathematical and numerical study of finned tube air cooled condenser for air conditioning unit with two ton refrigeration capacity using R22 as a base fluid and R407C an alternative fluid was investigated. Different parameters were considered in this work, such as condensing pressure, ambient temperature and refrigerant mass flow. A comparison of performance between two condensers when using R22 and R407C were performed. A redesign the condenser operates with the R407C to operate with the same system that operates with R22. The result showed the same behavior for the two refrigerants, the condensers are possible to work with R407C for the same geometry and some modifications in the structure of heat exchange with the same air velocity. The proposed model was validated with the outputs from the test data given in literature papers, derived from air cooled condensers with different dimensions. The results exhibited an agreement with the experimental results with a percentage of compatibility ± 10%.
Two lasers were utilized for silicon processing using photoelectrochemical etching and laser texturing in order to produce nano/micro structures, respectively. Photoelectrochemical etching process utilizes a CW diode laser of 532 nm wavelength was used to support electrochemical etching for both n-type and p-type conductivity. While laser texturing process was employed using pulsed fiber laser of 1064 nm wavelength. Various characterization methods were devoted to examine silicon micro/nanostructures surfaces produced by lasers. These methods include AFM, SEM and Raman scattering to provide clear evidence about formation of micro/nanostructures abundant at silicon surfaces. Moreover, FTIR analysis for the laser produced silicon surfaces could emphasize whether the resultant silicon surface is hydrophilic or hydrophobic. Image analysis software adopted a side view micro image was used to measure the contact angle between the water droplet and silicon micro/nano-surfaces. It is found that the laser produced silicon nanostructure by photoelectrochemical etching creates a hydrophobic surface and even super hydrophobic with contact angle of 130 degrees for 50 nm average size. In addition, utilizing fiber laser of high repetition rate for laser texturing produces microstructures that are super hydrophilic with contact angle could reach 8 degrees for a surface dimension of 50 μm.