×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerIt is essential to review and develop a system of water control structures and canals that can be used to manage high-flow discharges and the flood control plan requirement to modify the system's capacity. Al-Ramadi Project System is considered one of the main flood control projects on the Euphrates River within Anbar Governorate, Western Iraq. This study will focus on Al-Majjarah Canal and Regulator, which is part of Al-Ramadi Project and has the function of a link canal between Al-Habbaniyah and Al-Razazza lakes, and describe the capacity of the canal under typical operating conditions and during floods. The study used HEC-RAS 6.1 software to run a numerical model to simulate this canal. According to previous research studies near the research region on the Euphrates River, for the main canal, the roughness coefficient was taken at 0.026, and for the flood plain, it was taken at 0.03. The same parameter value was applied to Al-Majjarah Canal. Due to the study region's similar geology and nature. Moreover, a sensitivity analysis was made of the roughness coefficient and its influence on the water surface elevation for the canal. The model result indicated in the current situation of Al-Majjarah Canal can pass a flow rate of 1300 m3/s when Al-Razazza Lake is at an average water level that has been approved by the Ministry of Water Resources at 32.02 m.a.m.s.l.. If the water level in Al-Razazza Lake is in the semi-filled position of 40 m.a.m.s.l., it causes floods for the canal because the water level rises above the banks of the canal at the last kilometer from the canal, even when passing a few discharges through the canal. Accordingly, it is not possible to safely pass the flow rate for a flood wave with a 500-year return period predicted by the "Study of Strategy for Water and Land Resources in Iraq (2014)", which is 2000 m3/s for this canal, without making modifications to the expansion of Al-Majjarah Regulator by adding additional gates, expanding the entrance and exit of the Regulator, reshaping and expanding some cross-sections, and raising some of the banks for the canal. The above-mentioned modification were applied for the purpose of passing the expected discharge from the canal, while maintaining a freeboard of 1 m between the water surface and the canal banks.
The aim of this study is to evaluate the sediment transport and to assess the quality of water for a reach of Euphrates River with a length of (124.4 km), begins from downstream of Haditha dam which represents the upstream of study, and ends at Heet station in Heet city which represents the downstream. There are 196 cross-sections which were distributed along the study area by using the model of one-dimensional HEC-RAS version 4.1. Calibration and Verification processes from(01-Sep-2013) to (30-Nov2013) and (01-DEC-2013) to (28-FEB-2014) respectively, show that the optimal Manning Roughness Coefficient (n) is equal to (0.033) which gives the less error ratio between the observed and calculated water surface elevations. By comparing the results of sediment transport “mass accumulated” for this study which equal to (237.38ton/day) was larger than the value of the previous study which equal to (165ton/day, measured in 2010). But the value of sediment load of this study at Heet station was equal to (551.76 ton/day) which was less than the value of previous study (189.041×103 ton/day,measured in 1988), due to increasing in the rates ofdischarge that was arrived the reach of study area.