×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerDue to their very good mechanical properties of composite materials which led to a huge increase in its application in a lot of fields.Epoxy/ PS(polysulfide) composite materials behavior in fatigue was reported. different weight fraction of PS (2%,4% and6%) were studied .Surface roughness properties of the blended composites were found for all weight fraction of PS and their fatigue properties are studied .Fatigue test was carried with rotating bending method. The loading in the test was sinusoidal wave type. The loading wave ratio is R = -1 and the frequency of loading is applied to avoid temperature rise with a frequency equal to 5Hz. Fatigue strength ,fatigue life and fatigue limit of the tested composites from standard curves are calculated. The addition of PS resulted in an enhancement in the fatigue values and cause the surface roughness to decrease at a considerable rate, the blend hardness is reduced considering shore A test.
The effects of the ultrasonic peening treatment (UPT) on the rotating bending fatigue behavior and the behavior of the vibrations of alloy steel DIN 41Cr4 were studied. Hardness test, Tensile test, Constant amplitude fatigue tests, and the vibrations measurements have been carried out on the specimens. Also, the fracture surface was examined and analyzed by a Scanning Electron Microscope (SEM). The results of the investigations, e.g. stress to number of cycles to failure (S-N) curves, fatigue strength improvement factor was 7%. The decreasing percentage of maximum Fast Fourier Transform (FFT) acceleration of the ultrasonic peened condition compared to the untreated conditions was 45%.