×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerThe ability of fungal waste biomass type White Agaricus Bisporus to biosorb Pb(II) ,Cr(III), Cd(II) and Co(II) from wastewater was investigated in batch process. Single and binary mixtures were used at low metal concentration wastewater treatment. The size of the biosorbent ranged 0.3-1 mm. The biosorption capacity of the biosorbent was evaluated under equilibrium conditions at 25 °C. Results indicated that the biosorption capacity of waste of fungi for the binary mixture was always lower than that for a single component system. Eight isotherm models were used to fit the experimental data of single system and Langmuir model was found a suitable to describe the biosorption data. The maximum uptake capacity (qe) of Pb(II), Cr(III), Cd(II) and Co(II) in single system was 158.73, 46.94, 40.16 and15.94 mg/g respectively with correlation coefficients 0.999,0.998,0.988 and 0.991 respectively. For binary system, four biosorption models were used to fit the experimental data. Extended Langmuir model gave the best fitting. The removal percentage of heavy metals onto fungal waste biomass was in order of Pb(II) > Cr(III) > Cd(II) > Co(II) in both single and binary system. The results show that the using waste of fungi as a biosorbent of heavy metals gave a higher uptake capacity of four heavy metals.
The purpose of this study is to investigate the potential of biochar derived from Peganum harmala (Pgh) seeds as an adsorbent material for wastewater treatment. Biochar is a cost-efficient, ecologically friendly, and effective bio-sorbent for a wide range of pollutants in wastewater. Researchers are investigating the production of biochar from novel biomass sources. Phosphoric acid (H3PO4) was utilized in a chemical activation technique to produce biochar at various concentrations (20%, 30%, and 40%). The pyrolysis process lasted three hours at 600°C in a tube furnace with an inert nitrogen gas atmosphere. Elemental analysis, Brunauer-Emmett-Teller (BET) nitrogen adsorption, scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR), energy dispersive X-ray spectroscopy (EDX), The biochar was characterized using several techniques, including elemental analysis, X-ray diffraction, Fourier transform infrared spectroscopy (FTIR), Brunauer-Emmett-Teller (BET) nitrogen adsorption, scanning electron microscopy (SEM), and energy dispersive X-ray spectroscopy (EDX). The findings demonstrate the significant potential of Pgh seed-derived biochar as an inexpensive and ecologically acceptable sorbent material. A large surface area (691.58 m2g−1) was achieved at 600◦C for three hours with 40% H3PO4 activation.