×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerFunctionally graded material is one of the promising sectors of the material since because of the great ability to control with required product properties could be strongly used in biomedical applications exclusively in the implants sector, this review paper demonstrates briefly about the most prominent known manufacturing methods and focusing on the implants coated by FGM layer manufactured by using EPD method because the EPD has significant properties it could produce FGM layer in the Room temperature without depending on chemical reactions or heat adding, Biomedical application need highly accuracy when we deal with material that directly contact with human tissue because the heat effect could be change the biocompatibility properties and also the chemical reactions could make toxic effect on the produced implants, All these reasons make the EPD one of the favorable method for the FGM coated Implants. this paper will summarise and give the Gide line for the researcher about the most important substrate and suspension materials used in the EPD method and its application.
Photonic crystal fibers (PCFs) are generally divided into two categories: solid-core photonic crystal fibers and hollow-core photonic crystal fibers. In this paper, a long-period fiber Bragg grating (LPFBG) was experimentally fabricated in a hollow-core photonic crystal fiber (HC-PCF) using a CO₂ laser and based on the point-by-point technique. Proper LPFBGs were inscribed using laser powers of 0.9 W and 1.4 W, with grating parameters (grating period, length of each pitch, and depth of each pitch) equal to (136 µm, 48.042 µm, 16 µm) and (142 µm, 74.027 µm, 22.09 µm), respectively, for two samples. The Bragg wavelengths and full-width at half-maximum (FWHM) were (1529.274 nm, 1.34 nm) and (1529.629 nm, 5.11 nm), respectively, for the two samples fabricated using CO₂ laser powers of 0.9 W and 1.4 W. From these results, it was recognized that the optimal LPFBG-HC-PCF was the one fabricated using 0.9 W laser power. The unique structure of hollow-core photonic crystal fibers, which enables light propagation within the air core and provides a large internal surface area, has attracted significant research interest for various sensing و communication applications, Environmental and Biological Monitoring, and medical applications.
Whispering Gallery Mode Micro-Resonators (WGMRs) have received significant interest due to their great sensitivity to environmental changes, compact size, and ability to operate over a wide spectral range because their low optical losses produce high-quality factors so that they can be used in various sensing applications. This work investigates the design and implementation of cylindrical WGMRs for Refractive Index (RI) sensing for different delivery fiber diameters. Single Mode Fiber with different waist diameters (80,67.1,18) µm were used as delivery fibers. At the same time, the sensor (resonator) fiber is SMF with a diameter (125 µm). Quality factors and Free Spectral Range (FSR) were calculated and analyzed for each diameter. The quality factor for all diameters was in power of 104, which is considered good. The FSR is inversely proportional to fiber diameter. FSR values were (0.678,1.75,2.03) nm for (80,67.1,18) µm delivery fiber diameters respectively. An analyte prepared by NaCl with different refractive indices is used to investigate the RI sensor performance. Higher sensitivity is obtained from the WGMR with a smaller waist diameter, which is (-)74 nm/RIU. While for the delivery fiber diameters (80,67.1) µm were (-0.28, -9.27) nm/RIU respectively. The submitted sensor will have a good contribution in the field of chemical, biological and medical applications.