×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerThis paper discusses the development of a seven-band coherent wavelength-division multiplexing (WDM) system covering the T to U systems, aiming to enhance the capacity and system efficiency. Seven multiband systems (C+L, S+C+L, S+C+L+U, E+S+C+L, E+S+C+L+U, O+E+S+C+L+U, and T+O+E+S+C+L+U) are designed with 40 GBaud symbol rate, 50 GHz channel spacing, and dual-polarization (DP)-16QAM signaling. The analysis adopted the enhanced Gaussian noise model, considering the amplified spontaneous emission of inline optical amplifiers and nonlinear interference (NLI) from fiber nonlinear optics, including Kerr effect and stimulated Raman scattering (SRS) which it implemented using Matlab (Ver. 2020b) program. The results show that the optimal powers are -4, -5, -5, -4.5, -3.5, -6, and -4.5 dBm for the seven WDM systems, respectively. Further, with a fiber span length of 100 km, the C+L system has the longest transmission reach of 20 span. However, using S+C+L+U system gives the highest bit rate-distance product of 1619 Tbps.km. The O+E+S+C+L+U and T+O+E+S+C+L+U systems are designed with 50 km-span length to reduce the effect of NLI caused by the large numbers of channels (1060 and 1200, respectively).
Recently, there is increasing interest in using the 18 THz bandwidth offered by S+C+L band to increase the transmission capacity of fiber communication systems. This leads to the generation of ultra-wideband (UWB) wavelength-division multiplexing (WDM) optical communication systems. In these advanced systems, stimulated Raman scattering (SRS) causes a power transfer from high-frequency channels to low-frequency channels. This effect leads to an increase in the nonlinear interference (NLI) between the UWB-WDM channels. Power optimization techniques are required to balance transfer power between band channels, thus increasing the maximum transmission reach (MTR) along with increasing system capacity. In this paper, the transmission performance of S+C+L band system operating with dual-polarization 16-QAM signaling is investigated using enhanced Gaussian noise model. The transmitter and receiver for each DP channel use a -polarized laser and incorporate two identical configurations, one for x- and the other for y-state of polarization (SOP). The results are presented for two values of symbol rate, 40 and 80 GBaud, where the system carries 360 (=160+80+120) and 180 (=80+40+60) channels, respectively. The results revel that the MTR of both cases is equal to 12 100 km-spans when the channel lunch power equals to -4 and -2 dBm, respectively. This work also shows the effect of NLI components as a function of the number of spans, channel spacing, and channel launch power. The results show that the cross-phase modulation component of the NLI has high accumulated value with transmission distance, while the self-phase modulation component is almost constant.
The fifth generation (5G) and beyond mobile networks support increasing number of users with increasing bit rate per users. This has encouraged researchers to propose coherent digital subcarrier multiplexing (SCM) point-to-multipoint (P2MP) architectures to reduce the cost and complexity of optical transport networks, particularly in the metro aggregation scenario. However, coherent optical receiver is relatively costly and complexity compared with a direct-detection (DD) counterpart due to the use of a synchronized local laser. This paper addresses design issues and performance investigation of intensity modulation/direct-detection (IM/DD) P2MP optical networks. P2MP architectures are designed using digital RF multisubcarrier (MSC) waveform embedded on the intensity of continuous-wave (CW) laser beside direct-detection scheme. The design covers C- and O-band operation using a wavelength-division multiplexing (WDM) architecture. Further single- and double-polarization (SP and DP) versions are reported for each type of the networks. All the architectures are built in Optisystem version 15 environment and simulated for different network parameters, under the assumption of 25 Gbps per subcarrier data rate. The main performance measures are maximum route reach and bit rate-distance product (BDP). The simulation results indicate that DD networks can replaced the coherent counterpart when number of subcarriers per optical channel is 4. Further, the O-band P2MP networks offer high values of maximum reach and BDP than C-band counterparts.